Instructions for the fitter
Installation
These instructions are to be used by the fitter as a guide to
installation, setting and maintenance in line with current regulations
and standards. The appliance must be disconnected from the mains
before any work is carried out.
Installation (Fig. 5)
The appliance is designed for fitting into a worktop, as shown in the
figure.
Place the supplied sealant around the perimeter of the hob.
The hob should not be installed over an oven, although if this is the
case, check that:
- the oven is equipped with an appropriate cooling system
- there is no warm-air leakage from the oven towards the hob.
- suitable air inlets are provided as shown in the figure.
(Fig. 5)
1 Front view
2 Front side
3 Oven or cupboard zone
4 Air input
Electrical connection (Fig. 6)
Check the following before the electrical connection is made:
- the installation characteristics are in line with that indicated on the
specifications plate on the base of the hob surface
- the installation is fitted with an efficient earthing connection in line
with current regulations and law. The earth connection is a legal
requirement.
Where the appliance is not supplied with a cable or plug, use
suitable material for the current indicated on the specifications plate
and for the operating temperature. The cable must never reach a
temperature of more than 50ºC above the ambient temperature.
Fit a device for disconnecting from the mains power supply on the
fixed cable, with a contact separation at all the poles to permit total
disconnection in the event of category III over-voltage, in
accordance with wiring regulations.
The plug or omnipolar switch must be easily accessible when the
appliance is installed.
This appliance is not designed to be used with an external timer or
separate remote control system.
The manufacturers shall not in any way be held responsible in the
event of non-compliance with that indicated above and where
accident prevention regulations are not respected.
To avoid all risk, if the power cable is damaged it must only be
replaced by the manufacturer, by an authorised service centre
or by a qualified electrician.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce